Ni-Cu预合金爆炸箔电化学制备及电爆性能研究
基金项目:
应用物理化学重点实验室开放课题基金（No.6142602220102）。
Electrochemical Synthesis and Explosion Performance Study of Ni-Cu Pre-Alloy Exploding Foils
- 摘要
|
- 图/表
|
- 访问统计
|
- 参考文献
|
- 相似文献
|
- 引证文献
|
- 资源附件
|
- 文章评论
摘要:为探究电爆等离子体引发合金反应的点火机理，进一步降低爆炸箔发火电压、提高能量利用率，采用电化学方法在铜爆炸箔表面原位可控沉积Ni-Cu预合金薄膜。进行了预合金爆炸箔微观形貌、成分构成和电爆特性等实验研究，结合电爆炸反应过程监测探究了电爆合金化反应路径和释能机理。研究结果表明：采用电化学恒电位方法沉积金属Cu和Ni，当应用电位分别为-0.2 V和-0.8 V，反应时间均为2 700 s时，沉积的Ni-Cu预合金材料呈5 μm的立方体结构且分布均匀，无明显氧化物生成。所制备的Ni-Cu预合金爆炸箔在2 000 V充电电压下的能量利用率是Cu爆炸箔的2.11倍，在电爆发生50 μs后可观察到明显的合金化反应发生，等离子体膨胀范围和火花持续时间均明显大于Cu爆炸箔，更有利于等离子体直接点火。
Abstract:In order to explore the ignition mechanism of alloy reactions induced by electric explosion plasma, further reduce the ignition voltage and increase the energy utilization efficiency of the exploding foil (EF), an electrochemical method was proposed in this study to in-situ deposit Ni-Cu pre-alloy films on the surface of Cu EF. The morphology, composition and electric explosion characteristics were investigated systematically, then the alloy reaction path and energy release mechanism were explored combined with electric explosion reaction monitoring. The results show that the electrochemical potentiostatic method can be used to deposit Cu and Ni, the prepared Ni-Cu pre-alloy microcube are evenly distributed with the size of 5 μm, when the applied potentials are -0.2 V and -0.8 V, reaction time are both 2 700s, respectively and there is no obvious oxide formation. The energy utilization efficiency of prepared Ni-Cu pre-alloy exploding foil under 2 000V charging voltage is 2.11 times higher than that of Cu exploding foil, the alloying reaction can be observed clearly after electric explosion occured 50 μs later, the plasma expansion range and spark duration time are all significant larger than those of the traditional Cu EF, indicating its excellent electric explosion performance.
var swiper = new Swiper('.swiper_xq', {
navigation: {
nextEl: '.swiper-button-next',
prevEl: '.swiper-button-prev',
},
});
$(function(){
$('img').bigic();
});
jQuery(".slideTxtBox").slide({ trigger: "click" });
